Product Categories
Contact Us

ByTune Electronics Co.,Ltd

Manufacture Factory :

Add: A5 building , Songbai RD 3055 , Gongming Street, Guangming district,  ZhenZhen, 518100,China

Tel: 0755-27765981

Fax: 0755-8529 6631

Engineering: support@btslipring.com

 

Sales Office:

Tel: +86-755-2964 2158

Fax: +86-755-2350 3855 

Mobile: 189 2742 5032

Add:6th Floor, C building, New generation ;Hi-tech Park,28 district, Bao'an, ShenZhen,518125,China

Sales: sales@btslipring.com

Facebook: slipring1@hotmail.com

Twitter: btslipring

Skype:btslipring

 

US Office:

usoffice@btslipring.com

US Atlanta

Canada Edmonton

You are here: Home > News > Content
How To Install Through Hole Slip Ring?
Edit: ByTune Electronics Co.,Ltd    Date: Oct 09, 2016

Proper use and mounting instruction

Though bore slip rings series(LPT)

1).Caution:

 

Without specifying, this series slip ring only work in 60%RH or below humidity ,and -40+80 temperature environment.

 

Slip ring should be far away from dust and humidity environment.

 

If slip ring works outdoor, protection shielding is necessary.

 

Slip ring can not support the weight of equipment which connected with it, rotating equipment should be fastened so that its weight will not fall on the rotor.

 

No force to slip ring in the direction of parallel to axis.

 

No damage to the surface of lead wire while equipment rotating, all lead wire can not bear weight while being aligned.

Because of possible geometric mismatching between the customer’s application and the slip ring, “hard mounting ”of both ends of the slip ring (i.e., securing the rotor and stator such that is NO floating during operation) is not recommended and may cause premature failure.

 

Without specifying, all parameter should be within the range of specification indicated, such as :

 

Working Speed

Voltage

Current

Dielectric Strength

Protection

 

2).Installation Guide:

 

Shaft mounted units :

.Position the slip ring in the desirable location and tighten four set screws(Not  supplied) to the shaft.

. Route the wiring and make the necessary connections. Do not allow the wiring to restrict free rotation of the slip ring. Do not constrain wiring such that wire flexing (cold working) occurs. Doing so will ultimately cause failure(breakage of the wiring).

.Position screws or pins in the anti-rotation tab ,as drawing shows.

 

Flange mounted(Customized )units:

.Align the mounting holes in the flange to mounting base and install flat washers and mounting screws(NOT SUPPLIED).securely tighten screws.

. Route the wire and make the necessary connections. Do not allow the wire to restrict free rotation of the slip ring.

.Position screws or pins in the anti-rotation tab ,as drawing shows.

 

Feedback
ByTune Electronics Co.,Ltd