CATEGORIES
Contact Us

ByTune Electronics Co.,Ltd

Manufacture Factory :

Add: A5 building , Songbai RD 3055 , Gongming Street, Guangming district,  ZhenZhen, 518100,China

Tel: 0755-27765981

Fax: 0755-8529 6631

Engineering: support@btslipring.com

 

Sales Office:

Tel: +86-755-2964 2158

Fax: +86-755-2350 3855 

Mobile: 189 2742 5032

Add:6th Floor, C building, New generation ;Hi-tech Park,28 district, Bao'an, ShenZhen,518125,China

Sales: sales@btslipring.com

Facebook: slipring1@hotmail.com

Twitter: btslipring

Skype:btslipring

 

US Office:

usoffice@btslipring.com

US Atlanta

Canada Edmonton

Home > Knowledge > Content

How slip rings can simplify my rotating system while transferring power or signal ?

ByTune Electronics Co.,Ltd | Updated: Sep 08, 2017
Source:

http://www.btslipring.com/copper-rings-with-carbon-brushes-at


Slip rings are used in rotating electrical assemblies to make a continuous electrical connection between stationary and rotating part. This enables the stationary power source to transmit electrical power to the rotating component.
Basically, a slip ring is a band of electrically conductive material mounted on a shaft. Although insulated from the shaft itself, the slip ring is connected to the rotor or rotating assembly through windings or other electrical connections. The outer part of the slip ring is in continuous sliding contact with stationary brushes or other stationary conductors. Figure below shows the arrangement of Rings and Carbon Brushes.


slip ring and carbon brushes.jpg

Slip rings are used as a means of providing DC excitation to the rotor of the Alternator. 


The DC supply that we generate after rectification of the alternator output (Static Excitation system is considered here) is stationary but the rotor, to which it is to be fed, is rotating. So we bring out the rotor terminals and at their ends we connect slip rings which rotate along with the shaft. A brush, to which the DC supply is fed, remains in contact with the rotating slip rings and continuously feeds DC into the rotor winding as the slip rings ride over the brushes. We may consider slip ring and brush arrangement as an interface between the rotating rotor and the stationary DC supply. 



Feedback
ByTune Electronics Co.,Ltd